Skip to main content
Fort Collins Air Tech(833) 247-8350

Central AC installation and replacement in Fort Collins

A new air conditioner is a system decision, not a box swap. Here is what an independent contractor should cover with you before quoting a replacement or a first-time install.

Replacement or first install

Most Fort Collins jobs replace an outdoor condenser and the coil that sits on the furnace. Some houses have never had central air, and those jobs add a coil, a line set, a pad, a disconnect and a new circuit from the panel.

The City treats these differently. Its license for new residential installation work, HVAC(R), asks the contractor to show three completed new residential installs. Repair and replacement work falls under HVAC(RR) (Fort Collins license categories). If your house has no central air yet, ask which license the contractor holds.

Sizing comes before brand

An oversized condenser cools the air near the thermostat quickly and shuts off before it has pulled moisture out or reached the far bedrooms. An undersized one runs all afternoon in a July heat spell and still falls behind.

A proper load calculation looks at the house, not the old unit's label: window area and which way it faces, attic insulation, air leaks, and the duct runs. The old condenser may have been the wrong size for years.

The City's own permit page asks for load calculations (Manual J) for new heating or cooling systems in accessory buildings, and a mechanical design submittal when a remodel adds a complete system or changes the heating or cooling type (Fort Collins permit requirements). Asking for the numbers on an ordinary replacement is reasonable too.

New central air conditioner condenser set level on a fresh pad beside a ranch house

The parts that have to match

Central air is a split system. The outdoor condenser, the indoor coil and the furnace blower are rated as a set. Pairing a new condenser with an old coil, or with a blower too weak to push enough air across it, can leave the efficiency on the label unreachable.

  • Ask whether the quote replaces the indoor coil or reuses the old one, and why.
  • Ask whether the furnace blower can deliver the airflow the new coil needs.
  • Ask about the line set. Old copper may be reused if it is the right size and clean.
  • Ask where the condensate drain goes and whether a pump or safety switch is included.

The City permit

Air conditioner replacement is on the Fort Collins mechanical permit list alongside furnaces and heat pumps. The application is the City's heating or cooling permit form, emailed to Building Services or filed through its online over-the-counter form, and the fee is charged per appliance (Fort Collins mechanical permits).

If the job also needs an electrician or a plumber, the City asks for a remodel or alteration permit instead. Permits filed on or after 1 April 2026 are reviewed under the 2024 International Codes with local amendments (Fort Collins Building Services).

The contractor normally pulls the permit. If someone suggests skipping it, ask why, because the inspection is the only independent check on the installation.

Rebates for cooling, as they stand

Xcel Energy's Colorado page for stand-alone air conditioner rebates says invoices dated after 1 January 2024 are no longer eligible (Xcel residential cooling rebates). Xcel's incentives for cooling now run through heat pumps, which cool in summer and heat in winter.

Fort Collins and Loveland electric customers can also look at Efficiency Works, the program run for Platte River Power Authority's owner communities. Its retrofit rebates for heating and cooling equipment need a listed service provider, and the application is due within 45 days of finishing the project (Efficiency Works home rebates).

If a rebate matters to you, raise it on the first call. A contractor who is not on the program list cannot unlock it later. Our heat pump page sets out how Xcel's heat pump rebates are worked out.

What a complete quote shows

  • Model numbers for the condenser and the coil, and the matched efficiency rating for the pair.
  • Whether the furnace stays or is replaced at the same time.
  • Electrical work: disconnect, breaker size, and any panel changes.
  • The permit, and who schedules the inspection.
  • How the old refrigerant is recovered.
  • Warranty registration, and who files it.

Comparing two quotes line by line on these points tells you more than comparing the totals.

Installation questions

Should the furnace be replaced at the same time?

Not automatically. If the furnace is young and its blower suits the new coil, keeping it is common. If it is near the end of its life, doing both at once avoids reopening the same ductwork twice.

Can a new condenser go where the old one sat?

Usually, if the pad is level and the clearances still meet the code. Moving it means new line set and wiring, so ask whether the location is worth changing.

Is a heat pump an option instead?

Often, in a ducted house. A heat pump replaces the condenser and adds heating, with the furnace kept as backup or replaced. The heat pump page covers the Xcel rules.

How long does the old system have to last?

There is no set age. A system that cools evenly and does not leak can keep going; one that needs a compressor or keeps losing charge is a different conversation.

Hot upstairs, cold downstairs, or no air at all?

Tell the contractor what the system is doing and how old it is. They decide with you whether a visit, a repair or a new system makes sense.