Furnace and heating repair in Fort Collins
A gas furnace that will not light, lights and quits, or runs without warming the house. An independent contractor can trace the fault and quote the fix.
Read the furnace before you call
Most modern furnaces have a small window on the lower panel with a status light. The pattern of blinks is a fault code, and the chart is usually printed inside the door. Writing the pattern down helps the contractor arrive with the right part.
- Clicking, then silence: often an igniter or flame sensor problem.
- Burners light, then shut off within a minute: often a dirty flame sensor or a venting fault.
- Blower runs constantly: often a limit switch reacting to overheating, frequently from a blocked filter.
- Cold air at the start of each cycle that warms after a minute is normal.

Safety comes before diagnosis
If you smell gas, leave the house, then call Xcel Energy or 911 from outside. Do not switch lights or the furnace on or off on the way out.
If a carbon monoxide alarm sounds, get everyone outdoors first. Colorado law bars anyone from removing the batteries or disabling a CO alarm except to test, maintain or replace it (C.R.S. 38-45-102). An alarm that sounds is a reason to call, not to silence it.
Who supplies what
Inside the City, gas comes from Xcel Energy, and the City's own electrification page points homeowners with Xcel gas to Xcel for meter questions (City of Fort Collins). Electricity comes from Fort Collins Utilities, one of the four owner communities behind Efficiency Works (Efficiency Works).
That split matters for repairs. A furnace with no gas supply is an Xcel question; a furnace whose blower and controls are dead may simply have a tripped breaker or a switch at the cabinet turned off.
Repairs and the permit line
Fort Collins lets minor parts be replaced without a permit as long as they do not affect the approval or safety of the appliance. A new igniter or flame sensor is typically in that group. Replacing the furnace is not, and a gas line run for a heater needs its own mechanical permit (Fort Collins mechanical permits).
Gas piping is licensed separately in the City, under a Gas Piping license tied to the ICC G33 exam (Fort Collins Contractor Licensing). If the repair touches the gas line itself, ask whether that license is held.
Furnace repair questions
The furnace runs but the house stays cool. What does that point to?
A clogged filter, closed registers, a leaking duct in the attic or crawl space, or burners firing at low rate. The contractor will look at temperature rise across the furnace to narrow it down.
Is water around the furnace a heating problem?
On a condensing furnace, yes. It drains water through a trap and tubing, and a blocked drain can shut the furnace off. In summer the same puddle may be from the AC coil.
Should I reset the furnace myself?
Turning the power switch off and on once is fine. Resetting again and again without knowing why it locked out can hide a venting or flame problem.
Hot upstairs, cold downstairs, or no air at all?
Tell the contractor what the system is doing and how old it is. They decide with you whether a visit, a repair or a new system makes sense.